AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Scanmaster 2.1 adjustments9/3/2023 2.4 Warranty Information 9 3 SMC Product introduction 11 3. This year looking to rebuild stock turbo, change spark plugs from ac44ts to ac- delco 43. 1.2 Safety Labels 2 1.3 General Safety Guidelines 2 1.4 Customer Support 3 2 Introduction 5 2.1 General Notes 5 2.2 Using This Manual 5 2.2.1 Purpose 5 2.2.2 Revision History 5 2.3 Obtaining Technical Assistance Error Bookmark not defined. I ordered it from Turbotweak, I have TT 93-94 octane chip in the gn now with matching 009's, 340 pump, hotwired, Acufab reg(43psi), 17psi, hooker, stock downpipe,turbo, IC, stock MAF sensor, rjc PP, rjc BC, 160 t-stat, new body bushing, kirban rear seat brace kit, 25psi/vaccum, water gauge, rebuild trans/rebuild & mod stock convertor, rear main seal replaced with trans, no alky, besides the air cleaner looks original. On the display you will see O2 millivolt readings from the engine’s oxygen sensor. Run Mode When communication is established, the Scanmaster will enter Run mode. If no data is received the Scanmaster will show No Data. I should already have got this scantool 2.1 a couple of years ago. Power Up On initial key-on, the Scanmaster will attempt to connect. I hope it works like it should, looking forward to reading the car. I'II find a good ground somewhere.Just to keep it stock later without cutting any wires in the car.Thx again. I would rather use a connector plug (from the store) to join onto scanmaster wires for the power(IGN) and ALDL plug (pin E). Thx everybody for the feedback.The pics help me out greatly, To see installing the scantool 2.1 correctly.
0 Comments
Read More
Leave a Reply. |